Washing Machine Repair Dubai: How to Fix a Washing Machine

Washing Machine Repair Dubai: How to Fix a Washing Machine

No matter how well you take care of your washing machine, it will eventually break down, and you’ll be left with a big problem on your hands if you don’t know how to repair it yourself. Luckily, fixing your washing machine isn’t as hard as it seems—all you need to do is follow these simple steps to successfully fix your washing machine so that it’s working like new again in no time!

Step 1: Check Water Supply

Before you start any repair, it’s important to make sure that your washing machine has a water supply. If the water supply is turned off, the washing machine will not be able to fill up with water and operate properly. To check if your washing machine has a water supply, first locate the water shut-off valve. This is usually located near the Washing Machine Repair Dubai, but it may also be located near the sink or in the basement. Once you have found the shut-off valve, turn it on and off several times to make sure it is working properly. If the valve is not working properly, you may need to replace it.

Step 2: Replacing the Relay Switch

If your washing machine is not starting, it may be because the relay switch has burned out. To replace the relay switch, first disconnect the washing machine from the power source. Then, remove the access panel to the control board and locate the burnt-out relay switch. Finally, replace the switch with a new one and reassemble the washing machine.

Step 3: Replacing the Door Switch

The door switch is one of the most important parts of the washing machine, as it ensures that the door is closed before the machine starts. If your washing machine won’t start, it could be because the door switch is faulty. To replace it, first disconnect the power to the washing machine. Then, remove the screws that hold the door switch in place. Replace the old switch with a new one, and then screw it back in place. Finally, reconnect the power and test out your washing machine to see if it works properly now.

Step 4: Checking for Leaks

If your washing machine is leaking, the first thing you should do is check the hoses for any cracks or leaks. If the hoses are in good condition, then check the drain pump for any leaks. The drain pump is located under the washing machine. To access it, you will need to remove the back panel of the washing machine. Once you have access to the drain pump, check it for any cracks or leaks. If there are no leaks, then check the water inlet valve for any leaks. The water inlet valve is located behind the washing machine. To access it, you will need to remove the front panel of the washing machine. Once you have access to the water inlet valve, check it for any cracks or leaks.

Step 5 : Unclogging Filters

The first step is to unplug your washing machine from the power outlet. Next, locate the filters. There are usually two filters, a lint filter and a fabric softener dispenser. The lint filter is located near the bottom of the washer tub and the fabric softener dispenser is located on the side of the washer tub. If your washing machine has a front-load washer, the filters will be located behind the detergent dispenser drawer. To remove the lint filter, simply pull it out. To remove the fabric softener dispenser, unscrew it from the side of the washer tub. Once you have removed both filters, rinse them off with warm water and soap.

Step 6 : Testing the Drain Pump

To test the drain pump, you will need to disconnect the washing machine from its power source and remove the drain hose from the back of the machine. Next, locate the drain pump and remove it from the washing machine. With the drain pump removed, use a multimeter to test it for continuity. If there is no continuity, then the drain pump needs to be replaced.

Step 7 : Connecting Load Sensors

Connect the two black wires to the load sensors. These are usually located on the front of the washing machine, near the bottom. The wires will be labelled L1 and L2. If your washing machine does not have load sensors, you can skip this step.